What are the precautions for maintenance of led light belts?

Update:31 Aug 2020

LED lamp belt price consultation factory summary led la […]

LED lamp belt price consultation factory summary led lamp belt maintenance precautions

   1. Anti-static: Because LED is an electrostatic sensitive component, if you do not take anti-static measures when repairing the LED strip, it will burn out the LED and cause waste. It should be noted here that the soldering iron should use an anti-static soldering iron, and the maintenance personnel should also take anti-static measures (such as wearing a static ring and anti-static gloves).

  2. Continuous high temperature: The two important components of LED strips, LED and FPC, are products that cannot continue to withstand high temperatures. If the FPC continues to high temperature or exceeds its withstand temperature, it will cause the FPC cover film to bubble and directly cause the LED strip to be scrapped. At the same time, LEDs cannot withstand high temperatures continuously, and their chips will be burned out by high temperatures for a long time. Therefore, the soldering iron used when repairing the LED light strip should be a temperature-controlled soldering iron to limit the temperature within a range, and it is forbidden to change and set at will. In addition, even so, it is necessary to pay attention to the soldering iron not to stay on the LED pin for more than 10 seconds when repairing, if it exceeds this time, it is likely to burn the LED chip.

  3. Short circuit: Many LED strips are defective because there is a short circuit at the pin. The real reason should be found before repairing. Otherwise, after rashly replacing the bad LED, it will continue to cause the LED chip to be broken down by the short-circuit current when the power is turned on again. Therefore, before replacing a new LED, you must first find out the real cause of the defect, and you can get twice the result with half the effort by prescribing the right medicine.