News

LED solar street light installation process and precautions

Update:07 Nov 2019
Summary:

The LED solar street light system consists of LED light […]

The LED solar street light system consists of LED light source (including drive), solar panel, battery (including battery incubator), solar street light controller, street light pole (including basic) grade auxiliary wire and other parts.

The general installation steps are as follows:

Foundation pouring

1. Determine the position of the vertical lamp; if the surface is 1 m 2 is soft soil, then the excavation depth should be deepened, and it is necessary to confirm that there are no other facilities (such as cables, pipes, etc.) below the excavation position, and the top of the street lamp is not long. Time to shade the object, otherwise you should change the position properly.

2. Reserve (excavation) in the position of the vertical luminaire to meet the standard 1 m 3 pit; carry out the positioning of the embedded parts. The embedded part is placed in the middle of the square pit, one end of the PVC threading pipe is placed in the middle of the embedded part, and the other end is placed in the storage area of ​​the battery (as shown in the figure above). Pay attention to keep the embedded parts and foundation on the same level as the original ground (or the top of the screw is on the same level as the original ground, depending on the needs of the site), and one side should be parallel to the road; this will ensure that the pole is erected at the back end. Not skewed. Then, it is fixed by C20 concrete pouring, and the vibration of the vibrating rod should not be stopped during the pouring process to ensure the overall compactness and firmness.

3. After the construction is completed, the residual sludge on the positioning plate is cleaned in time, and the impurities on the bolts are cleaned with waste oil.

4. During the solidification process of the concrete, it should be watered and maintained regularly; until the concrete is completely solidified (usually more than 72 hours), the chandelier can be installed.