Installation method of four-wire LED strip

Update:18 May 2020

  LED lamp wholesale manufacturers share the insta […]


LED lamp wholesale manufacturers share the installation method of four-wire LED strip

1. The four-wire LED light strip has four wires, three rows of lights (note that it is not a four-row lamp ~ ~), each row of 1 meter 24 lights, 24 * 3 = 72. Because the power of each lamp bead is 0.05W, the power of the 72-bead LED lamp belt is: 72 * 0.05 = 3.6W.

2. The four-wire LED lamp has a bandwidth of about 22mm, a thickness of about 8mm, and a weight of about 0.25kg / m (4 meters and one kilogram). Each LED lamp belt must be equipped with a special plug (plug with a transformer); when connecting, it must be clear. Remove the plastic cover and connect it after connecting the test light. It can't be directly connected with a cover, so short circuit easily!

3. There is a "hinging and shearing" sign per meter, which can only be cut when the sign is cut. Miscutting or deviation will result in a meter that is not bright! Some will be deviated due to the sign, but carefully read the sign before cutting The position can be cut according to the place where the center is not connected. If you look carefully, you can tell.

4. When the LED light belt device is installed, it is usually placed in the lamp trough, and it can be straightened, or it can be fixed with a thin rope or thin iron wire. If you need exterior or vertical installation, you need to purchase another clip and tail plug. The original clip is fully transparent. Fortunately, after the device is finished, waterproof glass glue is put on the tail plug and the plug, so the waterproof function is better.